Voodoo Lab Pedal Power 2 plus in mint condition. With the brackets installed, all its cables AND bonus 2 cables / voltage doublers for 18/24v. Normally each one costs 11 euro new.

Exact specs:

8 isolated outputs sections eliminate ground loops and hum

All outputs compatible with 9V battery-operated pedals
Toroidal transformer and linear regulation for lowest possible noise
Delivers clean, consistent power even with poor AC line conditions
200-watt courtesy AC outlet for powering additional devices
Hand-built in the USA

230V 50/60Hz (Europe/Australia model)
5.5x2.1mm barrel connectors - center negative
Short circuit protected
Included Cables (Standard polarity DC cable 8-pack)
Custom-designed, ultra-low noise toroidal power transformer
Rear Courtesy Auxiliary AC outlet, 200 watts max
Dimensions: 6" x 3.4" x 1.8"(152 x 86 x 44 mm)
Weight: 2 lbs. (907g)

Pedal Power 2 PLUS Outputs

9/12V (x4) – Standard 9V and 12V Boss ACA
With each one of these four outputs delivering 100mA, you can easily power any 9V battery-operated pedals. Boss pedals that specify the PSA adapter operate at 9V like most other pedals. Boss pedals that require the ACA adapter operate at 12V which can be selected via switches underneath the Pedal Power 2 PLUS. Any one of these outputs can be individually selected to run at 9V or 12V.

9V (x2) – High Current 9V and Line 6 Modelers
These two outputs each deliver 250mA allowing you to run high current draw effects like the Boss DD-20 Giga Delay or Line 6 DL4 Delay Modeler. Via switches underneath the Pedal Power 2 PLUS, these two outputs can be separately configured for regulated (Boss Twin Pedals) or unregulated (Line 6 Modelers) power allowing you to run both units if so desired. These outputs can also power any standard 9V effects as well.

9V (x2) – Standard 9V With Battery Sag Control
These outputs each have an available 100mA of power, but also allow you to SAG the voltage from roughly 4V to 9V. The SAG control is mostly useful for transistor-based fuzz, octavia, and distortion circuits, as most modern opamp designs are minimally affected by variations in supply voltage.

18V/24V – Using Custom Cables
All of the outputs on the Pedal Power 2 PLUS (and the original Pedal Power) are completely isolated allowing you to create different voltages. You can run effects like the current MXR Flanger by combining two 9V outputs to create a single 18V supply. By switching two outputs into 12V ACA mode, you can join them together to create a 24V output for powering numerous Electro-Harmonix stompboxes including the Deluxe Memory Man.

Shipping fees for Europe/ England 18 euros - maybe lower when I get your details, as I will try to find the cheaper way to send. Overseas / rest of the world contact me to find the most economical way to ship. If in Athens, we can arrange local pickup for free, or between 5-10 euros with box now.