€ 110
Κατηγορίες Πεταλιών
- Amp modeling
- EQ
- Flanger
- Fuzz
- Guitar synths
- Loop & samplers
- Multi-εφέ
- Noise generators
- Gates & μείωση θορύβου
- Octave και pitch
- Overdrive & boost
- Πετάλια μπάσου
- Pedalboards & τροφοδοτικά
- Phase shifters
- Preamps
- Reverb
- Ring modulators
- Tremolo
- Tuning
- Vocal pedals
- Wahs & φίλτρα
- Άλλο
- Buffer
- Προσομοιωτές καμπίνας
- Chorus & vibrato
- Compression & sustain
- Controllers, volume & expression
- Delay
- Distortion
Μάρκα
Sound Sculpture
Μοντέλο
footsim
Κατάσταση
Μεταχ/μένο (άριστο)
Χώρα κατασκευής
United States
Χώρα
Greece
Νομός
Θεσσαλία
Πόλη
Larissa
Κωδικός
NOIZ617881
Δεκτή ανταλλαγή
Όχι
Περιγραφή
Πωλείται το Sound Sculpture footsim σε άριστη κατάσταση.
Στέλνω παντού με αντικαταβολή.
The FootSim footswitch simulator replaces the mechanical footswitches that are used with amplifiers to control the overdrive and reverb functions of the amp so that these functions can be controlled by a MIDI foot controller or other MIDI based device. TheFootSim may also be used to control any signal processor or other device that has a footswitch input.
The FootSim can simulate both a push on/push off (steady state) switch as well as a momentary type switch. Push/push switches are the type of switches used with most all traditional amps. Momentary switches are used to control more modern amps or for pulsing delay units that have a "tap" function for setting delay time from your MIDI foot controller.The FootSim is a relay based device, which is to say that relays are used to replace the mechanical footswitches. Using relays instead of the usual transistors insure that any device that normally uses mechanical switches can now be replaced with the FootSim without compatibility problems.
The FootSim can be controlled with either MIDI Program Change commands or with Control Change commands for use with "Instant Access Switches" available on some MIDI foot controllers
Manual: https://www.scribd.com/document/627840148/FootSim-user-guide
Στέλνω παντού με αντικαταβολή.
The FootSim footswitch simulator replaces the mechanical footswitches that are used with amplifiers to control the overdrive and reverb functions of the amp so that these functions can be controlled by a MIDI foot controller or other MIDI based device. TheFootSim may also be used to control any signal processor or other device that has a footswitch input.
The FootSim can simulate both a push on/push off (steady state) switch as well as a momentary type switch. Push/push switches are the type of switches used with most all traditional amps. Momentary switches are used to control more modern amps or for pulsing delay units that have a "tap" function for setting delay time from your MIDI foot controller.The FootSim is a relay based device, which is to say that relays are used to replace the mechanical footswitches. Using relays instead of the usual transistors insure that any device that normally uses mechanical switches can now be replaced with the FootSim without compatibility problems.
The FootSim can be controlled with either MIDI Program Change commands or with Control Change commands for use with "Instant Access Switches" available on some MIDI foot controllers
Manual: https://www.scribd.com/document/627840148/FootSim-user-guide
- 223 Προβολές
- Αναρτήθηκε: πριν 3 μήνες
- Αναφορά στη διαχείριση Αναίρεση αναφοράς